u kno my engine LOL but yes its the Series two where do i hook up the Boost gauge u wouldnt believe the stuff i have done tonite because of finding this site thanks

I haven't done one myself yet, but someone I know has his "T" 'd into a hard plastic line that runs across the rear valve cover. I really like his setup, he has an oil pressure gauge and boost gauge mounted in place of the ash tray. I'll have to post a pic.

very very nice !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!111 (;

now im really jealous dud i have no idear how to install a boost gauge will u help me out olds

http://www.bonnevilleclub.com/forum/kb.php?mode=article&k=47

this will help

dude thanks so much for ur help

so does that cover close up over the ash tray gauge?

Has anyone tried a window post setup?

the cover closed on both setups i had in the same location, but i trimmed a little off of the lip on the cover the second time. havent seen a pillar setup, but i dont like them normally and think it would be even worse in this scenario since it wouldnt keep up w/ the sleeperness of the car. i cant remember which illumination wire i tapped into or how i did it anymore.

i believe deekster_caddy (sp) has a pillar gauge setup

um i went to that site that shows how to put the boost gauge in on the Pontiac and I'm confused as to how you can measure boost using a vacuum path. Are there any ports below the roots on the manifold?

So the best place to run hoses and such through the firewall is through that plastic section near the brake pedal?