Series I (Supercharged) Write-Up Index

Last edited by AA on Thu Jul 02, 2009 8:59 am; edited 4 times in total

(Click on links)

Removing Broken Threads (Coolant Fitting)

M62 Supercharger Coupler Install

Lower Intake Manifold Replacement

Walpro Fuel Pump

Changing Water Pump

Installing aftermarket SC pulley on Series I

Replacing Radiator Cooling Fans

_________________

Subject: Re: Series I (Supercharged) Write-Up Index Fri Mar 06, 2009 3:36 pm

Might I suggest one for changing the super charger coupling ? My searches suggest that bearing failure is not common but it could also be included. I also noted that a new coupler runs about $30.00. ZZP brand was recommended but I have found no contact info.

Subject: Re: Series I (Supercharged) Write-Up Index Fri Mar 06, 2009 4:24 pm

RIVIERICA wrote:

Might I suggest one for changing the super charger coupling ? My searches suggest that bearing failure is not common but it could also be included. I also noted that a new coupler runs about $30.00. ZZP brand was recommended but I have found no contact info.

like this one?
http://rivperformance.editboard.com/series-i-engine-transmission-f13/write-up-95sc-changing-the-coupler-in-an-eaton-m62-t4421.htm

_________________

Subject: Re: Series I (Supercharged) Write-Up Index Fri Mar 06, 2009 5:11 pm

Thanks, Andrew. Added to the list!

_________________

Subject: Re: Series I (Supercharged) Write-Up Index Fri Aug 14, 2009 9:03 am

I am looking for a write up on replacing the Tensioner Pulley on a 95 Series 1 SC 3800.

I have chirping at an idle, the car has 101,500 miles. I am the 3rd owner and both previous owners maintained the car very well. I figure with this many miles I will replace the SC Coupler as well.

I see a lot of mentions of replacing the tensioner pulley just cant find a write up. It has been years since I have done my own wrench turning and I would rather not fudge it up.

_________________
GoRivDaddy
95 Supercharged White on Charcoal - 101K at purchase.

Subject: Re: Series I (Supercharged) Write-Up Index Fri Aug 14, 2009 9:28 am

There is not yet a specific write-up for Series I tensioner pulley install, but I would encourage you to create one!

Here is a SC pulley write-up that give some helpful info:

http://rivperformance.editboard.com/series-i-engine-transmission-f13/write-up-how-to-install-an-aftermarket-sc-pulley-series-i-t112.htm

Good luck!

_________________