The 8th Gen Riviera Resource
HomeDashboardFAQSearchRiviera Questions & AnswersWrite-Ups IndexRegisterRelated LinksMemberlistLog in
Share | 

 urethane motor mounts

Go down 

Name :
Location : Finger Lakes of New York State
Joined : 2007-05-31
Post Count : 6967
Merit : 134

PostSubject: urethane motor mounts   Mon Jun 25, 2018 4:58 pm

Anyone have any experience machining blocks of urethane?  I am thinking about custom machining engine/transmission mount inserts out of 50 or 60 durometer "tails" of urethane castings such as

? anyone ?  I found some info here (LINK) but wondered if anyone had *done* any. I'm thinking about grinding/drilling/cutting motor mount insert from urethane so I can quit replacing them with Anchor Rubbers.

Back to top Go down
urethane motor mounts
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Riviera Performance ::   General Tech :: Engine Bay-
Jump to: