Riv Performance
Would you like to react to this message? Create an account in a few clicks or log in to continue.

The 8th Gen Riviera Resource
 
HomeDashboardLatest imagesSearchRiviera Questions & AnswersWrite-Ups IndexRegisterRelated LinksLog in

 

 Headlamp lense removal

Go down 
+10
quickboat97
'96reese
BrokenDownInTheYard
IBx1
palermocorey90
99Rivman
jax95riv
Mr.Riviera
lionfish
cragmor
14 posters
Go to page : Previous  1, 2
AuthorMessage
albertj
Master
albertj


Name :
Location : Finger Lakes of New York State
Joined : 2007-05-31
Post Count : 8687
Merit : 181

Headlamp lense removal - Page 2 Empty
PostSubject: Re: Headlamp lense removal   Headlamp lense removal - Page 2 EmptySat Feb 03, 2018 1:41 pm

R1V 1T UP wrote:
I looked and removed all the screws to both headlamp assemblies. The front bumper panel is just too much in the way for the assemblies to make a clean exit. I tried holding the panel down enough to squeeze the lights through but it wasn't enough. They are both loose but the bumper is in the way. Since it is a parts car I am thinking of cutting the panel because the car is on three wheels. The front driver side is on the ground due to a rotted engine cradle and removed rack and pinion.
The front bumper is held on mostly by pushpins. I think there are 2 screws. Look close... look real close.
Back to top Go down
 
Headlamp lense removal
Back to top 
Page 2 of 2Go to page : Previous  1, 2
 Similar topics
-
» turn signal lense removal
» Red Lense Under License Plate
» catalytic converter delete?
» Exhaust removal from SC 3.8 II?
» NEW BEE - Caliper Removal

Permissions in this forum:You cannot reply to topics in this forum
Riv Performance ::   General Tech :: Exterior-
Jump to: