Riv Performance
Would you like to react to this message? Create an account in a few clicks or log in to continue.

The 8th Gen Riviera Resource
 
HomeDashboardLatest imagesSearchRiviera Questions & AnswersWrite-Ups IndexRegisterRelated LinksLog in

 

 Custom built Venturi intake, using garbage scraps

Go down 
+9
L67
IBx1
albertj
grisolm1
turtleman
AA
gmann3001
RidzRiv
c0reyl
13 posters
Go to page : Previous  1, 2, 3, 4
AuthorMessage
deekster_caddy
Master



Name : Derek
Age : 50
Location : Reading, MA
Joined : 2007-01-31
Post Count : 7717
Merit : 109

Custom built Venturi intake, using garbage scraps - Page 4 Empty
PostSubject: Re: Custom built Venturi intake, using garbage scraps   Custom built Venturi intake, using garbage scraps - Page 4 EmptyWed Apr 25, 2012 2:47 pm

LARRY70GS wrote:

Derek,
I tried to explain to him the same thing. He's convinced his car is faster with it. I gave up. smile

Yeah, I read that as well. Just figured I'd try a different wording.

I don't think you'll notice any performance change except maybe on the top end where the restriction might become apparent.

Do you feel a 'seat-of-the-pants' change? I can't tell you there isn't something different. But will you get "MORE POWAAAR" from this? Sorry, but no.

If you were injecting a fluid that required atomization, your pipe outside the venturi would be the place to do it.

-Derek
Back to top Go down
c0reyl
Addict
c0reyl


Name : Corey
Age : 31
Location : JMU virginia
Joined : 2011-07-25
Post Count : 569
Merit : 2

Custom built Venturi intake, using garbage scraps - Page 4 Empty
PostSubject: Re: Custom built Venturi intake, using garbage scraps   Custom built Venturi intake, using garbage scraps - Page 4 EmptyWed Apr 25, 2012 3:23 pm

Well, either way, my car is gunna be pretty damn slow. I guess ill leave it on until.I get a 0-60 and 1/4 time in and report back. If its faster than 8.5 and 16.9 then it worked, if not" then I rip out the venturi :p
Back to top Go down
 
Custom built Venturi intake, using garbage scraps
Back to top 
Page 4 of 4Go to page : Previous  1, 2, 3, 4
 Similar topics
-
» Built a crappy intake, for 10 bucks.
» Hood Scoops / Intakes
» GOOD IDEA:fwi/air intake,BAD IDEA:fender delete/H20 intake
» Write-Up: Installing FWI Filter, Heat Shield, Air Scoop
» Write-Up: Building a Custom PVC Fenderwell Intake

Permissions in this forum:You cannot reply to topics in this forum
Riv Performance ::   N/A 3800 Tech :: Series II N/A Engine, Transmission, PCM-
Jump to: