Riv Performance
Would you like to react to this message? Create an account in a few clicks or log in to continue.

The 8th Gen Riviera Resource
 
HomeDashboardLatest imagesSearchRiviera Questions & AnswersWrite-Ups IndexRegisterRelated LinksLog in

 

 Pending multi-function failure

Go down 
2 posters
AuthorMessage
racinfan
Addict
racinfan


Name : Joe
Location : Cleveland, OH
Joined : 2007-02-05
Post Count : 567
Merit : 5

Pending multi-function failure Empty
PostSubject: Pending multi-function failure   Pending multi-function failure EmptyWed Jun 20, 2007 1:02 am

Well I'm getting some nice turning signal click-clock sounds for a few seconds after the car sits for about 8 hours. It's been getting worse over the past few days. It also clicked a few times when I hit the brakes and it has magically turned off my cruise control too. All the issues happen within 5 minutes of a cold start. It all goes away after 5 minutes though.

Am I right in the assumption that this is the start of a failure of my multi-function switch? Has anyone else had these type of issues before?
Back to top Go down
1998 Riv
Expert
1998 Riv


Name : Dave
Age : 64
Location : In The AZ Oven
Joined : 2007-01-17
Post Count : 4502
Merit : 44

Pending multi-function failure Empty
PostSubject: Re: Pending multi-function failure   Pending multi-function failure EmptyWed Jun 20, 2007 1:10 pm

Don't know, but I'd start shopping Ebay just in case. Or Ed Morad. I got one on Ebay for $49. GM new is a few hundred.
Back to top Go down
racinfan
Addict
racinfan


Name : Joe
Location : Cleveland, OH
Joined : 2007-02-05
Post Count : 567
Merit : 5

Pending multi-function failure Empty
PostSubject: Re: Pending multi-function failure   Pending multi-function failure EmptyWed Jun 20, 2007 8:00 pm

What happened when yours went bad?
Back to top Go down
1998 Riv
Expert
1998 Riv


Name : Dave
Age : 64
Location : In The AZ Oven
Joined : 2007-01-17
Post Count : 4502
Merit : 44

Pending multi-function failure Empty
PostSubject: Re: Pending multi-function failure   Pending multi-function failure EmptyThu Jun 21, 2007 12:03 am

racinfan wrote:
What happened when yours went bad?

It didn't yet. I was just planning ahead, and couldn't pass up a NEW one for $49. Perfectly new in the wrapper. All the lettering perfect. Don't know how, but the Ebay seller got his hands on a few of them and was selling last fall. Most of my white lettering is gone, one of the few places on the car that shows any wear. I'll probably change it out in a couple years.
Back to top Go down
Sponsored content





Pending multi-function failure Empty
PostSubject: Re: Pending multi-function failure   Pending multi-function failure Empty

Back to top Go down
 
Pending multi-function failure
Back to top 
Page 1 of 1
 Similar topics
-
» MAP failure
» Brake line failure
» Transmission Trouble, Slipping?? (Series I SC)
» Power trunk failure
» autometer gauge failure

Permissions in this forum:You cannot reply to topics in this forum
Riv Performance ::   General Tech :: Audio & Electronics-
Jump to: